Set for 4 zones.

Consisting of a touch remote control and 4 dimmers

With this product you can control up to 4 different areas separately or together. (e.g. 4 separate showcases or shelves) Each area is assigned its own zone button on the remote control. All 4 areas can be switched on and off and controlled at the same time using the master button.

You need your own dimmer for each area and the appropriate power supply. Select the desired number of dimmers under “Number of zones” on the right. You must order suitable power supplies separately depending on the LED product.

The dimmer has a remote control with a dimmer wheel for manually selecting the desired brightness. The range of the remote control is approximately 30 meters. If the power supply is interrupted (e.g. via a switch), the last selected brightness is saved. When the power is switched on again, the dimmer continues to operate with the same setting. You need a power supply with 12V DC or 24V. The voltage you need to use depends on the LED products to be operated.

The LED items are connected to V+ and LED- (OUTPUT) and the power supply to + - (INPUT). A parallel connection of several consumers is also possible using the screw terminals. You can plug power supplies with a DC hollow plug (5.5mm outside - 2.5mm inside - plus pool inside / minus pool outside) directly into the socket of the LED dimmer.

12V / 24V LED dimmer with touch radio remote control. It has a radio remote control with a dimmer wheel for manually selecting the desired brightness. The range of the remote control is approximately 30 meters.

If the power supply is interrupted (e.g. via a switch), the last selected brightness is saved. When the power is switched on again, the dimmer continues to operate with the same setting. With this controller you can either control multiple controllers together with just one remote control synchronously (within a radius of 30 meters), or you can operate multiple controllers separately with multiple remote controls. You need a power supply with 12V DC or 24V. The voltage you need to use depends on the LED products to be operated.

The LED items are connected to V+ and LED- (OUTPUT) and the power supply to + - (INPUT). A parallel connection of several consumers is also possible using the screw terminals. You can plug power supplies with a DC barrel plug (5.5mm outside - 2.5mm inside - positive pole inside / negative pole outside) directly into the socket of the LED dimmer.

Always connect the consumer (LED item) first Then turn on the power supply, otherwise a short circuit may occur. This can damage or destroy the controller. Disconnect the power supply from the power circuit before connecting the cables.

To operate the remote control you need 2 x standard AAA batteries. The batteries are NOT included.

Eine große Auswahl an Artikeln zur Regalbeleuchtung finden Sie bei unserem Partner LEDS24.com.